1 remove the connector and disassemble the detachable part.
2 the cable end is fixed, nail on the shaft plate, the end of the end of the 200mm-300mm, the end of the head and the direction of the horizontal direction into a 30 degree angle of about -45.
3 for hand or electric knife stripped of a period of about 45mm long cable sheath, required to maintain a straight section.
4 (87 glue or 703 glue sealant in the surface of the sheath and the outer conductor junction (the back end of the connector cover can cover a part of) evenly in a circle, (pressing ring), gaskets, seals ring are sequentially set in the cable, along the direction of a spiral outer conductor will be connected with the connecting sleeve rotatably mounted in the outer conductor of get rid of the sheath, close to the cable sheath end cover of the rear end of the connector.
5 copper brush will remain in the cable head of the sheath powder, copper scrap and other clear clean.
6 distance connecting sleeve end face 2mm or so with special metal scissors to cut off excess corrugated copper tube outer conductor. Using a pointed nose pliers will corrugated copper tube outer conductor outward flaring, flanging and pliers, hammers and other tools suitable for tapping, the flat against the end face of the shell body. Note the flanging required uniform, round.
7 water pliers, file, abrasive tools such as removal of sharp corners, sleeking burr.
8 to smooth copper pipe inner conductor, with a handsaw close to the fixed outer conductor amputate out outer conductor insulating tape strips and the inner conductor, repair flat conductor (wrinkles) copper tube end with a file, edges and corners, taps tapping, depth and guide component thread length to adapt; on the wrinkled lines within the copper conductor, water pliers cut out outer conductor insulating strips, with special metal scissors to cut the inner conductor of the appropriate length.
9 screw the inner conductor assembly onto the inner conductor (wrinkle) copper tube. For smooth copper tube inner conductor, application Kesi clamp screw; corrugated copper tube inner conductor should be the components of the inner conductor and inner conductor is connected to the screw thread is screwed into the inner conductor about 2mm, pliers, hammers and other appropriate tools to tap the inner conductor, inward flanging, the conductor assembly package in the inner conductor; and the inner conductor is connected to a module of thread dew in outside. The contact flange and the inner conductor of the tight assembly requirements.
10 the conductor assembly, outer conductor and the inner conductor assembly is fixed, within the conductor assembly, a shell body which is orderly connected, tighten, installation solid (generally under the conductor assembly, outer conductor and the inner conductor assembly is fixed, conductor component, a shell body installation without the need to remove, then only the conductor assembly and the inner conductor assembly outer shell body and connecting sleeve are respectively screwdriver to turn the port, and a casing body of rotation within the conductor assembly).
11 the sealing rings, gaskets, rear end cover folded in turn, wrench the rear end cover and a set screw connection, wipe excess sealant.
12 will be inserted into the inner conductor assembly